+====================================================================+
|   REALTEK RTL8150 USB Fast Ethernet NIC Driver Setup Utility       |
|            for Windows 98(SE)/ME/2000/XP NDIS Driver               |
|                           Release Note                             |
+====================================================================+

How to use this RTLSetup Utility
---------------------------------
For Windows ME:

1. If the Operating System's New Hardware Wizard prompts you that
   "New Hardware Found" for the "USB Ethernet 10/100", you should
   click "Next" until "Finish" is clicked and without specifying
   location of the driver. You will see the "USB Ethernet 10/100"
   in the Device Manager.

2. Then you can install or update the NDIS driver with "setup" or
   "setup -s" command:
   a) setup: The InstallShield will prompt you the steps to install
             or upgrade the driver. 

   b) setup -s: The InstallShield will complete the installation or
                upgrade without prompting you any instruction.

   You need to reboot the system immediately after the Install shield 
   completes the installation/upgrade.

3. Do not click "Cancel" during New Hardware Wizard searches for the
   driver.

4. You can remove sET8150 utility from Add/Remove Program Palette in
   Control Panel, the InstallShield will prompt you the steps to remove
   the driver. After remove the driver, please restart the system
   immediately.

For Windows 2000:

1. If the Operating System's Found New Hardware Wizard prompts you that
   "New Hardware Found" for the "USB Ethernet 10/100", you should click
   "Next" until "Finish" is clicked and without specifying location of
   the driver. You will see the "USB Ethernet 10/100" in the Device
   Manager.

2. Then you can install or upgrade the NDIS driver with "setup" or
   "setup -s" command:
   a) setup: The InstallShield will prompt you the steps to install
             or upgrade the driver. 

   b) setup -s: The InstallShield will complete the installation or
                upgrade without prompting you any instruction.

3. You can remove sET8150 utility from Add/Remove Program Palette in
   Control Panel, the InstallShield will prompt you the steps to remove
   the driver. After remove the driver, please restart the system
   immediately.
